![]() disarm the system silently on a one-off basis by pressing the Black button of the remote just prior to pressing the gray button to arm/ disarm. If the arm/ disarm tones are enabled it is still possible for the driver to arm. If the system is put in the ferry mode a lower tone will be heard as the black button is pressed within 10 seconds of arming via the Grey button to confirm movement sensor deletion. If the arming tones are enabled the system will give an audible tone to coincide with the indicator flashes. This returns you to the software switch selection. Once you have made the adjustment press both buttons of the remote to exit switch 6. If you want to turn the tones Off, press the Black button of the remote control when switch 6 has been entered and the LED will be Off. Press the Grey button to turn tones On and the LED will change to On. Then a triple beep will be heard and the LED will be off. If anyone needs any help or a wiring diagram for the S4 alarm or the location/colours of the wires on the bike, PM me and I will let you know - wont make them public for obvious reasons. Select software switch 6 by pressing both buttons of the remote until you hear 6 beeps. stevewyatt69 said: Alarm now nicely installed - did it myself with a set of instructions for the Datatool alarm from an insider I know. EU regulations do not allow this feature to be active so it is shipped off. Want your Arm/ Disarm tones On When you arm or disarm this feature will allow for a tone and parking lights will flash indicating arming or disarming. ![]() You will a series of increasing rate beeps. Next time you start your bike/ Turn the ignition on the alarm will automatically rearm. Press both keys (Gray and BlacK) at the same time for 10 seconds until you hear a beep Insert key and start bike- Turn ignition on ![]() Got the DataTool S4 Series Training (Dealer) Manual.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |